Fip- 1.P13 Paper Damage - Oki B6500 Troubleshooting Manual

FIP- 1.P13 Paper damage

Before commencing troubleshooting, check the paper transfer course. Make sure there is no foreign
articles on the transfer course, such as staples, paper clips, scraps of paper and so on.
Step
Checking the paper feeding
1 Observe the paper feeding condition.
Is the paper fed crooked?
Checking the paper condition
Have new, dry and recommended paper on.
2 Carry out a test printing. (Refer to Chapter 2 Diagnostic
[TEST PATTERN MODE MENU].
Dose the problem still occur?
Check the paper transfer course.
Check if there are any stains or obstacles on the paper
3 transfer course between the paper feeding tray and the
exit tray.
Are there any obstacles on the paper transfer course?
Checking the rolls on the paper transfer course
Check all the rolls on the course, where the paper
transfer between paper feeding entrance tray and exit
4 tray, and check if there are any stains, wear or dam-
ages.
Are there any stains, wear or damages on the rolls in
the paper transfer course?
Checking Heat Roll and Pressure Roll
Remove FUSER ASSY. (RRP8.8)
Warning; Start the operation after the FUSER ASSY
have cooled down.
5
Turn the Gear HR with a finger, and check the Heat Roll
and Pressure Roll.
Are the Heat Roll and Pressure Roll damaged or
stained?
Print defect
The paper comes out from the printer crumpled, folded or
worn-out.
ESS and possible causes
- FUSER ASSY (PL8.1.20)
- Heat Roll
- Pressure Roll
- PWBA ESS (PL12.1.13)
- 150 FEEDER ASSY (PL5.1.1)
- EP CARTRIDGE
- BTR ASSY (PL8.1.21)
- Paper Cassette
- PLATE ASSY BTM (PL2.1.10, PL4.1.10)
- 150 Paper Feeder
- 550 FEEDER ASSY (PL7.1.10)
- Option 550 Paper Feeder
Check
1 – 131
Chapter 1 Troubleshooting
Yes
Go to FIP-1.P12
Go to step 2.
Skew.
Go to step 3. End of work
Remove the obsta-
cles or stains from
Go to step 4.
the paper transfer
Replace the dam-
Go to step 5. aged or worn-out
Replace FUSER
Go to step 6.
No
course.
rolls.
ASSY.
(RRP8.8)