Fip2.3 Paper Jam/Exit To Dup - Oki B6500 Troubleshooting Manual

FIP2.3 Paper Jam/Exit to Dup

Step
Possible causes:
HVPS/MCU (PL12.1.19)
SENSOR DUP (PL21.1.34)
ACTUATOR DUP (PL21.1.37)
ROLL DUP (PL21.1.17)
ROLL PINCH (PL21.1.4)
MOTOR DUPLEX (PL21.1.29)
1 Does Error occur, when the power is turned ON?
Checking the paper at ACTUATOR DUP
2 Open COVER HSG DUP.
Does the paper remain at ACTUATOR DUP?
3 Does Error occur, when the power is turned ON?
Checking Option Duplex installation
Remove Option Duplex, and then reinstall.
4
Does Error occur, when running a test print by Duplex
printing?
Checking paper position (1)
Open COVER HSG DUP.
5
Does the front end of paper reach the top roller of ROLL
DUP?
Checking transmission of driving force Remove
COVER LEFT (PL21.1.25).
6
Do ROLL DUP and every Gear rotate smoothly?
Turn the gear with a finger to check.
Checking ROLL DUP and ROLL PINCH
Open COVER HSG DUP and insert paper, and then
close it.
7
Is the paper transferred smoothly?
Turn the upper GEAR ROLL (PL21.1.20) clockwise with
a finger, and check paper transfer.
Checking MOTOR DUPLEX
Does MOTOR DUPLEX rotate normally?
8
Check using Chapter 2 Diagnostic [Duplex Motor,
Clockwise Normal Speed Test].
Check
1 – 72
Chapter 1 Troubleshooting
Yes
Go to step 2. Go to step 4.
Remove the
Go to FIP2.10
paper, and go to
SENSOR DUP.
step 3.
Go to FIP2.10
Go to step 4.
SENSOR DUP.
Go to step 5. End of work
Replace FUSER
Go to step 6.
ASSY. (RRP8.8)
Replace the dis-
Go to step 7. turbing part of rota-
Replace the dis-
Go to step 8. turbing roll of trans-
Replace HVPS/
Go to FIP2.9
MCU.
MOTOR DUPLEX.
(RRP12.10)
No
tion.
fer.