Electrical Connection (Required) - Travis Industries 21 TRV GSR2 Installation Manual

Electrical Connection (required)

 The electrical line to the grounded receptacle inside the fireplace must be installed by a qualified
installer and must meet all local codes.
 Make sure the household breaker is shut off prior to working on any electrical lines.
 The appliance, when installed, must be electrically grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical
Code, CSA C22.1.
 The electrical line must be a min. 14 gauge, and supply 120 Volts at 60 Hz (2 Amps).
Label all wires prior to disconnection when servicing controls. Wiring errors can cause
Caution:
improper and dangerous operation.
Remove the cover from the
a
fireplace junction box.
Travis Industries
Installation
(for qualified installers only)
Remove the knock-out from the cover plate.
c
Secure the romex connector to the cover plate. Route
d
the electrical line through the cover plate and attach the
electrical leads. Replace the cover plate.
The connection wires and a romex clamp
b
are inside the junction box.
NOTE: An alternative knock-out is
provided in the base of the
fireplace if you wish to run the
electrical line from below.
4150309
23
100-01421