Lp Conversion Instructions - Travis Industries 21 TRV GSR2 Installation Manual

Finalizing the Installation

LP Conversion Instructions

The GSR Stepper Motor Kit (SKU 94400999) is required for converting this appliance to LP. The kit contains the
stepper motor (regulator), torx wrench, and pilot orifice.
WARNING
This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer's
instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in
these instructions is not followed exactly, a fire, explosion or production of carbon monoxide may result causing
property damage, personal injury or loss of life. The qualified service agency is responsible for the proper
installation of this kit. The installation is not proper and complete until the operation of the converted appliance is
checked as specified in the manufacturer's instructions supplied with the kit.
CAUTION:
The gas supply shall be shut off prior to disconnecting the electrical power, before proceeding with the
conversion.
IMPORTANT:
A converted appliance must have a label attached marked with the following:
"This appliance was converted to _____ gas with Kit No. _____ by _____ (name and address of organization
making the conversion), which accepts the responsibility that this conversion has been properly made. This
control has been converted for use with gas_____."
Install the conversion kit prior to installing the gas line to ensure proper gas use.
Remove the glass (see page 37). Remove the logs and embers (if installed - page 42)
1
Remove the burner following the directions below.
2
Travis Industries
Lift the burner directly
up to remove.
Burner Replacement:
Make sure the burner manifold
inserts over the front (left) orifice.
Make sure the burner is fully seated and pilot hood lines up
with the burner holes at the rear edge of the burner.
4150309
(for qualified installers only)
45
100-01421