Global Vlan1Q Tagged Vlan Configuration Commands; Garp Status; Figure 31-1 Tagged Vlan Configuration And Activation Example; Figure 31-2 Cpu Vlan Configuration And Activation Example - ZyXEL Communications Dimension ES-3124PWR User Manual

Dimension ES-3124PWR Ethernet Switch
The following procedure shows you how to configure tagged VLAN.
Use the IEEE 802.1Q tagged VLAN commands to configure tagged VLAN for the switch.
3.
•
Use the
vlan <vlan-id>
automatically enters the
•
Use the command when you are finished configuring the VLAN.
exit
•
Use the
interface <port-list> command
on a port, then use the pvid <vlan-id> command to set the VLAN ID you created for the port-list to
that specific port in the PVID table.
•
Use the
inactive
Example:
ras(config)# vlan 2000
ras(config-vlan)# name upl
ras(config-vlan)# fixed 10-12
ras(config-vlan)# no untagged 10-12
ras(config-vlan)# exit
ras(config)# interface 10-12
ras(config-interface)# pvid 2000
ras(config-interface)# exit
ras(config)#

Figure 31-1 Tagged VLAN Configuration and Activation Example

Configure your management VLAN.
4.
•
Use the
vlan <vlan-id>
and the switch will activate the new management VLAN.
•
Use the
inactive
Example:
ras(config)# vlan 3
ras(config-vlan)# inactive
ras(config-vlan)#

Figure 31-2 CPU VLAN Configuration and Activation Example

31.4 Global VLAN1Q Tagged VLAN Configuration Commands

This section shows you how to configure and monitor the IEEE 802.1Q Tagged VLAN.
31.4.1

GARP Status

Syntax:

show garp

This command shows the switch's GARP timer settings, including the join, leave and leave all timers.
31-2
command to configure or create a VLAN on the switch. The switch
mode.
config-vlan
command to deactivate the VLAN(s).
command to create a VLAN (VID 3 in this example) for managing the switch,
command to disable the new management VLAN.
to enter the config-interface mode to set the VLAN settings
IEEE 802.1Q Tagged VLAN Commands