Operation; Cooking Procedures; Toaster Components - Holman QCS2 series Installation And Operation Instructions Manual

OPERATION

ROTARY POWER SAVER SWITCH
For toasters equipped with a Rotary Power Saver Switch, turn clockwise or counterclockwise to get in
the following positions.
FULL POWER
When in this position your equipment is at full power and ready to use.
OFF ROTARY
Two off positions are provided, a single rotation to either direction will shut the unit off.
STANDBY
The standby position reduces the power consumption by 75%. Using this position during the quiet
times will save electricity, and keep the toaster warm. When needed, turn the switch to FULL POWER.
Recovery time is about 30 seconds.
CERTAIN SURFACES ARE EXTREMELY HOT DURING OPERATION AND CARE
SHOULD BE TAKEN WHILE USING THIS UNIT.
CAUTION

COOKING PROCEDURES

BREAD TOASTING
Some toasters are equipped with a swinging heat shutter at the toaster entrance. This shutter will move
out of the way as the product passes under it.
1) Turn the power saver to FULL POWER.
2) Set the conveyor speed to HIGH.
3) If your toaster is equipped with separate top and bottom heat controls set them both
at HIGH.
4) Allow warm up time of 5 to 10 minutes.
5) Place a sample product on the conveyor belt to test the settings.
•If toasting is too light, turn conveyor speed control counterclockwise to a slower speed.
•If toasting is too dark, turn heat control to a lower heat.
(NOTE: Some products may require adjustment of the top and bottom heat controls in
order to achieve the desired results)

TOASTER COMPONENTS

LOAD UP
CRUMB TRAY
HIGH LIMIT RESET
SPEED CONTROL
HEAT CONTROLS
POWER SAVER SWITCH
AIR INTAKE FAN
IL1386
5
QCS
FRONT
POWER CORD