Cleaning - Holman QCS2 series Installation And Operation Instructions Manual

QCS

CLEANING

QCS
Preventive maintenance for your Holman toaster consists of the following recommended cleaning
e
®
procedures. To keep your toaster in its top operating condition, these steps should be performed on a
daily or weekly as indicated.
A. Clean air intake on bottom of unit.
B. For lightly soiled conveyor belts, turn conveyor speed control to fastest setting (100) and
C. Turn main power saver switch to the OFF position. Disconnect unit from power source.
D. After the unit cools, remove interior crumb tray (as shown below) and clean.
E. Wipe exterior surface of unit.
DO NOT IMMERSE OR LET THE UNIT
STAND IN WATER.
DO NOT HOSE DOWN THE UNIT OR THE
TABLE/COUNTER IF THE UNIT IS ON THE
TABLE/COUNTER.
WARNING
KEEP AWAY FROM RUNNING WATER.
wipe with a damp cloth (daily) For heavily soiled conveyors, turn conveyor speed control to
fastest setting and wipe with a light abrasive pad (as needed).
Slide crumb tray back into position.
OPERATE
CLEAN
CRUMB TRAY REMOVAL
10