Daily Operation; Power Saver - Holman QCSe-3 SERIES Installation And Operation Instructions Manual

Conveyor toaster
Table of Contents

Advertisement

WARNING
DO NOT CUT OR REMOVE THIS PLUG OR GROUNDING PRONG FROM THE
PLUG.
WARNING
CONNECT/PLUG UNIT INTO DEDICATED A.C. LINE ONLY SPECIFIED ON THE
DATA PLATE OF THE UNIT.

DAILY OPERATION

The Holman QCSe conveyor toaster comes with pre-programmed
factory default settings for TOAST, MUFFINS, and BAGELS. The
operator may change these setting at any time. A button labeled
OTHER is provided to allow the operator to program settings for
additional product(s).
Press TOAST and TST will appear in the display.
Press MUFFIN and MUF will appear in the display.
Press BAGEL and BGL will appear in the display.
Press OTHER and OTH will appear in the display.
LIGHT and DARK buttons are used to change the conveyor speeds
when in toast, muffi n, or bagel modes.
Pressing the (LIGHT) button once will increase the conveyor speed
by 15%. Pressing twice (XLIGHT) will increase the conveyor speed
by 30%.
Pressing the (DARK) button once will decrease the conveyor speed
by 10%. Pressing twice (XDARK) will decrease the conveyor speed
by 20%.
Note: After 60 seconds the conveyor speed will return to the
pre-programmed setting.
The factory default settings are as follow:
TOAST AND OTHER
TOP HEAT
9
BOTTOM HEAT
9
CONVEYOR
59
OTHER:
TOP HEAT
9
BOTTOM HEAT
9
CONVEYOR
59
The QCSe toaster is equipped with a Power Saver Switch (SAVER)
that reduces the power used by the toaster after a pre-programmed
period of time. This Power Saver Switch has three modes:
ON:
Unit is in pre-programmed power saving setting.
OFF:
Power Saver mode is turned off.
AUTO ON:
Power Saver turns on when there has been no activity
for a programmed length of time.
The operator may adjust the level of power reduction for the saver
mode. (Note: conveyor may move slowly when in saver mode.)
Two buttons (+) and (-) are used when increasing or decreasing the
value of each programmable setting.
A red LED light located at the lower portion of the control panel label
will indicate if the value for top heat, bottom heat or conveyor speed
is being adjusted.
5
BAGEL:
TOP HEAT
9
BOTTOM HEAT
9
CONVEYOR
24

POWER SAVER:

TIME (minutes)
60
HEAT
5

Advertisement

Table of Contents
loading

Table of Contents