Start-Up; Daily Operation; Operating Hints & Safety; Toaster Components - Holman QCS2 series Installation And Operation Instructions Manual

QCS
CERTAIN SURFACES ARE EXTREMELY HOT DURING OPERATION AND CARE SHOULD
BE TAKEN WHILE USING THIS UNIT.
CAUTION
START UP
When the toaster has been plugged into a suitable outlet and power supply, the word OFF will be
displayed on the L.E.D. read out.
A. Press the ON/OFF button once to turn on the toaster. The toaster will now enter into pre-heat and
PREHT will be displayed (the elements will begin to glow but the conveyor and fan motor will not
turn on).
B. After one minute, the fan motor will turn on and the conveyor will begin turning at the previously
saved setting (for initial start up, the drive motor will operate at the factory default setting).
C. After four minutes, the display will show the last used program selection i.e. TOAST, BAGEL,
MUFFIN or OTHER (for initial startup, TOAST will be the last program selected).

DAILY OPERATION

Check the power cord to insure that it is plugged into a proper outlet.
Press the ON/OFF button once to turn the toaster on.
Press the button a second time to turn the toaster off.
NOTE:
The words COOL and DOWN
OFF will be displayed until the ON/OFF button is pressed again.
For units equipped with a POWER SAVER feature, the three operating modes are:
ON
OFF
AUTO
mode until one of the menu buttons has been pressed.
Once the toaster has been pre-heated, the menu buttons can be pressed to change to TOAST, BAGEL,
MUFFIN, or OTHER.
OPERATING HINTS AND SAFETY
Disconnect power to the unit with the ON/OFF button at the end of each day of operation.
Do not leave the unit in operation without an attendant.
Do not leave the unit at high temperature when not in use or during idle periods. This will cause food
CAUTION

TOASTER COMPONENTS

LOAD UP
CRUMB TRAY
e
®
Unit has entered the pre-programmed level of power savings.
Power Saver feature is turned off.
If the toaster has been idle for a pre-set period of time, the unit enters Power Saver
HIGH LIMIT RESET
LCD DISPLAY
CONTROLS
8
FRONT
AIR INTAKE FAN
IL1385
POWER CORD