Holman DT14 SERIES Installation And Operation Instructions Manual

Holman DT14 SERIES Installation And Operation Instructions Manual

Double conveyor toaster

Advertisement

®
DOUBLE CONVEYOR
TOASTER
MODEL
DT14 SERIES
Installation and
Operation
Instructions
2M-HG0194 Rev. D 8/6/07
DT14
1

Advertisement

Table of Contents
loading

Summary of Contents for Holman DT14 SERIES

  • Page 1 ® DOUBLE CONVEYOR TOASTER MODEL DT14 SERIES Installation and Operation Instructions 2M-HG0194 Rev. D 8/6/07 DT14...
  • Page 2: Safety Symbol

    SAFETY SYMBOL These symbols are intended to alert the user to the presence of important operating and maintenance instructions in the manual accompanying the appliance. RETAIN THIS MANUAL FOR FUTURE REFERENCE NOTICE Using any part other than genuine Star factory supplied parts relieves the manufacturer of all liability.
  • Page 3: Specifications

    SPECIFICATIONS: 9H-DT14 Type: Double Conveyor Toaster 208V, 4,800 watts, 60 hz, 23.6 amp, NEMA 6-30P 220V, 4,800 watts, 60 hz, 22.3 amp, NEMA 6-30P 240V, 4,800 watts, 60 hz, 20.5 amp, NEMA 6-30P 220V, 4,800 watts, 50 hz, 22.3 amp, not supplied with cord or plug 240V, 4,800 watts, 50 hz, 20.5 amp, not supplied with cord or plug Product Opening TOP = 1"...
  • Page 4: Inspection & Assembly

    INSPECTION & ASSEMBLY UNCRATING AND INSPECTING Unpack the unit and components from the shipping container. Remove all visible packing material and those from inside the cooking chamber. If damage is discovered, fi le a claim immediately with the carrier that handled the shipment. Do not operate the unit if it was damaged during shipping.
  • Page 5: Crumb Trays

    CRUMB TRAYS The DT14 is equipped with two (2) crumb trays that are positioned under each conveyor. Operating the unit without the crumb trays will cause it OPERATE to operate at a higher temperature which will lead to unit shutting down. CLEAN Be sure to wipe the crumb trays clean using a damp cloth, each day.
  • Page 6: Daily Operation

    HIGH LIMIT RESET Your Holman Conveyor Toaster is equipped with a temperature activated heat limit switch that will interrupt the power to the heater tubes if the temperature inside the control box exceeds 190° F (88°C). The HIGH LIMIT/RESET can be manually reset by pushing the button located at the rear of the control box as shown below.
  • Page 7: Cooking Procedures

    CAUTION CERTAIN SURFACES ARE EXTREMELY HOT DURING OPERATION AND CARE SHOULD BE TAKEN WHILE USING THIS UNIT. COOKING PROCEDURES A. BREAD TOASTING 1) Turn the top and bottom heat controls to FULL POWER. 2) Set the conveyor speed to HIGH. 3) If your toaster is equipped with separate top and bottom heat controls set them both at HIGH.
  • Page 8 CLEANING Preventive maintenance for your Holman toaster consists of the following recommended cleaning procedures. To keep your toaster in its top operating condition, these steps should be performed on a daily or weekly as indicated. A. Clean air intake on the front of the unit using a damp cloth. (Daily) B.
  • Page 9: Maintenance Procedures

    MAINTENANCE PROCEDURES A. REPLACING HEATER TUBES 1) DISCONNECT UNIT FROM POWER SOURCE. 2) Remove the side panels. 3) Remove heater tube wire from terminal block connection, keeping top and bottom wires separate. 4) Lift heater tube retainers by loosening retaining screws and sliding the retainer plate up. Hand tighten the plate to hold it up so the heater tubes will slide out freely.
  • Page 10: Troubleshooting Guide

    D. HEAT LIMIT SWITCH (RESET) Your Holman conveyor toaster is equipped with an automatically activated heat limit switch that interrupts the heater tube connections if the ambient temperature in the control box exceeds 190°F (88C).
  • Page 11 Visit our Website at: www.star-mfg.com Email: service@star-mfg.com THOROUGHLY INSPECT YOUR UNIT ON ARRIVAL This unit has been tested for proper operation before leaving our plant to insure delivery of your unit in perfect condition. However, there are instances in which the unit may be damaged in transit. In the event you discover any type of damage to your product upon receipt, you must immediately contact the transportation company who delivered the item to you and initiate your claim with same.
  • Page 12 UPPER DECK - TOP HEAT ORANGE UPPER DECK - LOWER HEAT ORANGE LOWER DECK - TOP HEAT BLUE LOWER DECK - LOWER HEAT ORANGE BLUE UPPER LOWER DRIVE DRIVE SPEED SPEED BLACK CONTROL CONTROL YELLOW YELLOW LOWER DRIVE PILOT PILOT LOWER DECK UPPER TOP UPPER DRIVE...
  • Page 13 UPPER DECK - TOP HEAT ORANGE UPPER DECK - LOWER HEAT ORANGE LOWER DECK - TOP HEAT BLUE LOWER DECK - LOWER HEAT ORANGE BLUE UPPER LOWER DRIVE DRIVE SPEED SPEED CONTROL CONTROL BLACK YELLOW YELLOW LOWER DRIVE PILOT PILOT LOWER DECK UPPER TOP UPPER DRIVE...
  • Page 14 SOME ITEMS ARE INCLUDED FOR ILLUSTRATIVE PURPOSES ONLY AND IN CERTAIN INSTANCES MAY NOT BE AVAILABLE ® This drawing contains information confidential to Star Manufacturing International, Inc. No reproduction or disclosure of its contents is permitted. STAR MANUFACTURING INTERNATIONAL, INC. MODEL: DT14 SK2136 REV.
  • Page 15: Parts List

    PARTS LIST August 6, 2007, Rev. D DT14 Double Conveyor Toasters Number Part Number Description & Model Number Unit HM-401125 TOP COVER ASSY HM-400899 SHUTTER, HEAT 2C-200005 SCREW, 6-32 x 1/2 PHILLIPS, HEAT SHUTTER HM-401710 BAFFLE HM-100996 BACK PANEL ASSY HM-150027 CHAIN, DRIVE 24 IN.
  • Page 16 PARTS LIST August 6, 2007, Rev. D DT14 Double Conveyor Toasters Number Part Description Number Unit Number HM-120034 CHASSIS, DT14 2C-1487 SCREW 6-32X1/4 RHP ST. FUSEHOLDER 2C-H8669 WASHER #6 INT STL NP 2C-2553 NUT 6-32 HEX STL NP 2A-202902 FUSE, 5A - CLASS G 2E-Z5681 FUSEHOLDER, CLASS G 2E-200757...

Table of Contents