Operation - Holman T2 Installation And Operation Instructions Manual

Solid state slot toaster
Table of Contents

Advertisement

OPERATION

Color Selection
For first toasting, set adjustment knob between "Light and Dark." Drop bread in toasting wells. Press
down front handle as far as it will go. This automatically lowers the bread, turns on the heating
elements and starts the timing. When toast is finished it will pop up and automatically turn off the
elements. Adjust the color selection knob until the correct setting is desired.
Turn "LEFT" for a lighter toasting and "RIGHT" for a darker toasting.
Bread Release
Avoid lifting the handle to inspect the product while it is toasting. Restarting the toaster will reset
the timing cycle and toast may burn. The toaster is automatic and will pop up the toasting cycle is
finished. The manual bread release is for use in emergencies only.
Toasting Hint:
For best results use  day old bread. Some breads will toast better if dropped in sideways or upside
down. Different brands of bread will have various toasting qualities. Very fresh or moist bread of
uneven texture and bread that is not sliced evenly will not make good toast. Avoid use of small
unevenly cut slices. When using different kinds of bread, it may be necessary to change the timer
adjustment to get the desired color. Sliced bread that has been opened will be dryer on one side than
the other and it will toast darker on the dryer side.
Check Line Capacity 4 Slice Toaster
On the 4 slice toaster, adjust each section independently with the other section turned off. After both
sections are properly adjusted, and with out changing the adjustments, make toast in both sections at
the same time. If it takes longer and if the color of toast is lighter when both sections are operated at
the same time, it usually indicates that the electric line supplying the current is not heavy enough to
carry the load. In such cases larger wires are to be used to supply sufficient current to the toaster.
CLEANING
Keep toaster clean and free of excessive crumbs. To remove crumbs, remove tray, empty crumbs
then push the tray back in place. Crumb tray must be in place before toasting.
If partially opened, it will disturb the proper timing.
Do not immerse toaster in water or hose down with water to clean. Use a damp soft
CAUTION
cloth with a very mild soap to wipe down outside of toaster.
5
Operating
Lever
Color
Selection
Knob
IL1545
Crumb
Tray

Advertisement

Table of Contents
loading

This manual is also suitable for:

T4Ct4Bt4

Table of Contents