Cleaning; Daily - Holman QT14B Installation And Operation Instructions Manual

CLEANING

Preventive maintenance for your toaster consists of the following recommended cleaning procedures.
To keep your unit in its top operating condition, these steps should be performed on a daily, weekly or
as indicated.
Turn power off and allow cooling fans to run until the control box is cooled off. A thermostat in the
control box controls the fans.
DISCONNECT UNIT FROM POWER SUPPLY OR TURN POWER OFF AT WALL
BREAKER.
WARNING

DAILY

1. Turn main power switch to the OFF position. Disconnect unit from power source and
allow to cool.
2. Using a mild detergent, wipe exterior surfaces, clean with a damp cloth.
3. Remove the unload tray by lifting it out of position. Clean using mild detergent and warm
water.
4. Remove all three (3) crumb trays.
Clean crumb trays by wiping with a damp cloth and mild detergent.
DO NOT use caustic cleaners.
Place trays back in place prior to putting unit back into operation.
5. Check air intake area for dust and grease. To clean, vacuum and wipe with a dry cloth. (daily)
DO NOT spray cleaning fluids into the air intake or cooking chamber.
This may result in component failure.
6. If your unit has the glass window, carefully remove and clean the window. Remove the
thumbscrews securing the window assembly. Remove the window retainer, spacer, and the
piece of glass.
Wash with hot, soapy water. Reassemble.
7.
THE GLASS THAT IS SUPPLIED WITH SOME OVENS IS SPECIFICALLY DESIGNED
FOR IT. DO NOT SUBSTITUTE ANY OTHER GLASS PRODUCTS IN ITS PLACE.
NEVER OPERATE THE OVEN WITHOUT THE GLASS. NEVER ATTEMPT TO TOUCH
OR REMOVE THE GLASS WHILE THE OVEN IS HOT. ALLOW THE OVEN TO COOL
FOR SEVERAL HOURS BEFORE STARTING THE CLEANING PROCEDURE.
CAUTION
a. For lightly soiled build-up, clean with a damp cloth.
b. For heavily soiled build-up, use a soft damp cloth and mild detergent.
DO NOT use caustic cleaners.
Reconnect power.
THUMBSCREWS
p/n:2C-200015
GLASS
SPACER
RETAINER
Toaster Window Access (certain units)

IL1154