Advertisement
CLEANING PROCEDURES
1. Clean air intake on bottom of unit.
2. For lightly soiled conveyor belts, turn conveyor speed control to fastest
setting and wipe with a damp cloth. For heavily soiled conveyors, turn conveyor
speed control to fastest setting and wipe with a light abrasive pad.
3. Turn main power switch to the OFF position.
4. After the unit cools remove interior crumb tray (as shown below) and clean.
Slide crumb tray back into position. DO NOT OPERATE UNIT WITHOUT
CRUMB TRAY IN PLACE AS THIS CAUSES OVERHEATING IN THE
CONTROL BOX.
5. Wipe exterior surface of unit.
RESET/HIGH LIMIT
REFER TO ENCLOSED LAMINATED MAINTENANCE SHEET INCLUDED WITH TOASTER
NOTE:
LUBRICATION OF DRIVE CHAIN WITH GRAPHITE BASED LUBRICANT IS REQUIRED AS PERIODIC
MAINTENANCE. CALL HOLMAN FACTORY SERVICE DEPARTMENT FOR DETAILS.
OPERATOR'S MANUAL
HOLMAN CONVEYOR TOASTERS
MODEL DT14-M
FOR FURTHER INSTRUCTIONS
CRUMB TRAYS
PAGE 3
Advertisement
