Configuring Tcp/Ip On Windows 95, 98, Or Nt Computers - Netopia R5100 User Reference Manual

5-2 User's Reference Guide
Be sure you have connected the cables and power source as described in Step 1 "Connect the Router" guide
contained in your Netopia folio.
Before you launch the SmartStart application, make sure your computer meets the following requirements:
System Windows 95, 98, or NT operating system
software
Connectivity TCP/IP must be installed and properly
software configured. See
Windows 95, 98, or NT computers" on
page 5-6
Connectivity Ethernet card (10Base-T)
hardware
Browser Netscape Communicator™ or Microsoft Internet Explorer, included on the Netopia CD.
software Required for web-based registration and web-based monitoring.
Notes:
The computer running SmartStart must be on the same Ethernet cable segment as the Netopia
R5000 Series Router. Repeaters, such as 10Base-T hubs between your computer and the Netopia
R5000 Series, are acceptable, but devices such as switches, 10/100 bridges, or other routers are
not.
The Easy setup option in SmartStart for the PC will offer to set your TCP/IP control panel to "Obtain
an IP address automatically" if it is not already set this way. This will cause your computer to reboot.
If you have a specified IP address configured in the computer, you should make a note of it before
running SmartStart, if you do not want to use the dynamic LAN IP addressing features built in to the
Netopia Router. You may choose to use the console cable to connect directly to the console-based
management. Alternatively, you can restore your computer to its fixed IP address after changing the
default LAN IP addressing scheme of the router to match.
PC
"Configuring TCP/IP on
Macintosh
MacOS 7.5 or later
MacTCP or Open Transport TCP/IP must be
installed and properly configured. See
"Configuring TCP/IP on Macintosh
computers" on page 5-10.
Either a built-in or third-party Ethernet card
(10Base-T)