Table of Contents
Advertisement
The following procedure describes how to use Network Address Translation.
1.
Pick a network number for your local network (referred to as the internal network). This can be any IP
address range you want. The Netopia R5000 Series Router has a default IP address of 192.168.1.1. You
may choose to change this address to match a pre-existing addressing scheme. For this example, we will
use 10.0.0.0.
Note: The outside world (the external network) will not see this network number.
2.
Using the internal network number, assign addresses to the local nodes on your LAN. For example, you
could assign
10.0.0.1 to your Netopia R5000 Series Router
10.0.0.2 to a node running as a World Wide Web server
10.0.0.3 to an FTP server
10.0.0.4 to a Windows NT PC
10.0.0.5 to a Windows 95 PC
Note: See
"Associating port numbers with nodes" on page
3.
In the connection profile, toggle Address Translation Enabled to Yes or No (Yes to enable NAT) and press
Return.
The Easy Setup connection profile is accessible by using either of the following two approaches:
From the Easy Setup menu in the Main Menu screen, select the next screen, Connection Profile 1: Easy
Setup Profile.
The Easy Setup Profile screen appears.
Address Translation Enabled:
IP Addressing...
Local WAN IP Address:
Local WAN IP Mask:
PREVIOUS SCREEN
Toggle to Yes if this is a single IP address ISP account.
Enter basic information about your WAN connection with this screen.
Connection Profile 1: Easy Setup Profile
IP Setup and Network Address Translation 9-3
9-7.
Yes
Numbered
163.176.107.2
255.255.255.0
NEXT SCREEN
Advertisement
Table of Contents
