Suzuki RM-z450 Owner's Service Manual page 82

5-6 ENGINE REMOVAL AND INSTALLATION
INSTALLATION
Install the engine in the reverse order of removal. Pay attention to the following points:
• Fit the swingarm in its position and hold it with the swingarm pivot shaft.
• Mount the engine on the frame.
• Tighten the engine mounting bolts, nuts and swingarm pivot shaft nut to the specified torque.
The engine mounting nut is the self-lock type and cannot be used repeatedly. If the self-lock
effect is lose, replace it with a new one.
55 N·m
(5.5 kgf-m, 40.0 lb-ft)
70 N·m
(7.0 kgf-m, 50.5 lb-ft)
• Install the engine sprocket 1 and snap ring 2.
Replace the snap ring with a new one.
Seat the snap ring in the groove and locate its end as
shown in the illustration.
# 09900-06107: Snap ring pilers
CAUTION
LH
CAUTION
RH
55 N·m
(5.5 kgf-m, 40.0 lb-ft)
Thrust
Sharp
edge