Suzuki RM-z450 Owner's Service Manual page 231

• Apply thin coat of the engine oil to the new O-ring.
• Install the fuel delivery pipe 4 to the fuel pipe 5.
Replace the O-ring with a new one.
Never turn the fuel delivery pipe while pushing it.
• Tighten the fuel delivery pipe mounting screws to the speci-
fied torque.
$ Fuel delivery pipe mounting screw:
• With the throttle valve fully closed, install the TP sensor 6
and tighten the TP sensor mounting screw to the specified
torque.
Replace the O-ring with a new one.
NOTE:
* Apply thin coat of the engine oil to the O-ring.
* Align the throttle shaft end C with the groove D of TP sensor.
* Apply grease to the throttle shaft end C if necessary.
# 99000-25010: SUZUKI SUPER GREASE "A"
% 09930-11950: Torx wrench (T25)
$ TP sensor mounting screw: 3.5 N·m (0.35 kgf-m, 2.5 lb-ft)
NOTE:
* Make sure the throttle valve open or close smoothly.
* TP sensor setting procedure. ("12-18)
• Connect the Yellow button E side of the fuel hose to the throt-
tle body side.
Be sure to connect the fuel hose by your hand. You
may not connect the fuel hose with any tool.
• Install the starter knob/idle screw 7 to the lower hole.
CAUTION
3.5 N·m (0.35 kgf-m, 2.5 lb-ft)
CAUTION
CAUTION
FUEL SYSTEM AND THROTTLE BODY
or equivalent
13-14