Oil Seal Installation; Oil Pump No.1 And No.2 Removal - Suzuki RM-z450 Owner's Service Manual

11-5 LUBRICATION SYSTEM

OIL SEAL INSTALLATION

• Install the oil seal and snap ring 1 with the special tool.
Replace the oil seal and snap ring 1 with new ones.
NOTE:
Take care not to scratch the oil seal by the snap ring pliers when
installing the snap ring.
" 09913-70210: Bearing installer set
Oil seal: # 22 Attachment
09900-06108: Snap ring pliers
• Apply grease to the oil seal lip.
$ 99000-25010: SUZUKI SUPER GREASE "A"

OIL PUMP No.1 AND No.2 REMOVAL

OIL PUMP No.1
• Drain engine oil. (!2-11)
• Drain engine coolant. (!14-3)
• Remove the brake pedal. (!17-18)
• Remove the kick starter lever and right crankcase cover.
(!8-3)
• Remove the clutch component parts. (!7-8)
• Remove the snap ring 1, washer 2 and oil pump idle gear
3.
" 09900-06107: Snap ring pliers
• Remove the dowel pin 4 and O-ring 5.
• Remove the oil pump No.1 6.
• Remove the following parts from the oil pump No.1.
Outer rotor 7
Inner rotor 8
Pin 9
Oil pump No.1 plate 0
Oil pump No.1 cover A
Oil pump driven gear shaft B
CAUTION
or equivalent