Suzuki RM-z450 Owner's Service Manual page 156

10-11 TRANSMISSION AND CRANKSHAFT
INSTALLATION
• Press the new bearings with the special tool.
Bearing 1: % 55 Attachment
Bearing 2, 8: % 40 Attachment
Bearing 3: % 75 Attachment
Bearing 4: % 32 Attachment
Bearing 5: % 52 Attachment
Bearing 6: % 72 Attachment
Bearing 7: % 37 Attachment
Bearing 9: % 15 Attachment
" 09913-70210: Bearing installer set
• Press the bearing 0 with the appropriate steel rod.
NOTE:
Press the bearing (2, 5, 7, 8)into the crankcase, so that the
sealed side A faces outside of the crankcase.
NOTE:
Press the bearings (1, 3, 6) into the crankcase, so that the
stepped side C faces inside of the crankcase.
• Apply THREAD LOCK SUPER to the bearing retainer screws.
& 99000-32030: THREAD LOCK SUPER "1303"
• Tighten the bearing retainer screws to the specified torque.
' Bearing retainer screw: 8.5 N·m (0.85 kgf-m, 6.0 lb-ft)
B Outside of the crankcase
D Inside of the crankcase
or equivalent