How To Connect The Router - NETGEAR DG834 ADSL Firewall Router DG834 DG834 Reference Manual

Note: The Resource CD included with your router contains an animated Installation Assistant to
help you through this procedure.

How to Connect the Router

There are four steps to connecting your firewall:
Install ADSL filters on the phone lines.
1.
Connect the router to the ADSL filter.
2.
Log in to the router.
3.
Connect to the Internet.
4.
Follow the steps below to connect your router to your network. Before you begin, locate the ADSL
configuration information from your Internet Service Provider (ISP).
1. I ADSL F
NSTALL
You need to install a filter on every telephone or device that shares the same phone
a.
number as your ADSL router. Select the filter that came with your router.
One-Line Filter
Two-Line Filter
With Splitter
Figure 3-3: ADSL microfilters
Note: If you purchased the DG834 in a country where the filter is not included, you must
acquire one.
Two-Line Filter Example. Insert the two-line filter into the phone outlet and connect the
b.
phone to the phone line connector (A):
Connecting the Router to the Internet
Reference Manual for the ADSL Firewall Router DG834
P
ILTERS ON THE HONE
Phone
DSL
Phone
202-10005-05, June 2005
L .
INES
Splitter
3-5