How To Set Up A Gateway-To-Gateway Vpn Configuration - NETGEAR DG834 ADSL Firewall Router DG834 DG834 Reference Manual

Reference Manual for the ADSL Firewall Router DG834
• The DG834 has a LAN IP address of 192.168.3.1.
• The VPN client PC has a dynamically assigned address of 192.168.2.2.
While the connection is being established, the Connection Name field in this menu will say "SA"
before the name of the connection. When the connection is successful, the "SA" will change to the
yellow key symbol shown in the illustration above.
Note: While your PC is connected to a remote LAN through a VPN, you might not have
normal Internet access. If this is the case, you will need to close the VPN connection in
order to have normal Internet access.

How to Set Up a Gateway-to-Gateway VPN Configuration

Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
covered by these VPNC-recommended parameters, refer to
Tunnels in Special Circumstances" on page 7-35
Follow this procedure to configure a gateway-to-gateway VPN tunnel using the VPN Wizard.
A
14.15.16.17
DG834 VPN Firewall
192.168.0.1
PCs
Figure 7-20: Gateway-to-Gateway VPN Tunnel
Set the LAN IPs on each DG834 to different subnets and configure each properly for the Internet.
The examples below assume the following settings:
7-20
Table 7-2 on page 7-5. If you have special requirements not
VPN Tunnel
Virtual Private Networking (Advanced Feature)
202-10005-05, June 2005
"How to Set Up VPN
to set up the VPN tunnel.
B
22.23.24.25
DG834 VPN Firewall
192.168.3.1
PCs