NETGEAR DG834 ADSL Firewall Router DG834 DG834 Reference Manual page 31

Connect the Ethernet cable (C) from your DG834's LAN port to the Ethernet adapter in
c.
your computer.
C
Figure 3-6: Connecting a computer to the DG834 ADSL router
Note: The DG834 ADSL router incorporates Auto Uplink
port will automatically sense whether the cable plugged into the port should have a 'normal'
connection (for example, connecting to a computer) or an 'uplink' connection (for example,
connecting to a switch or hub). That port will then configure itself to the correct configuration.
This feature also eliminates the need to worry about crossover cables, as Auto Uplink will
accommodate either type of cable to make the right connection.
Connect the power adapter to the router and plug it in to a power outlet. Verify the
d.
following:
The power light is lit after turning on the router.
The ADSL link light is solid green, indicating a link has been established to the
ADSL network.
Now, turn on your computer. If software usually logs you in to your Internet connection,
e.
do not run that software. Cancel it if it starts automatically. Verify the following:
The local lights are lit for any connected computers.
Connecting the Router to the Internet
Reference Manual for the ADSL Firewall Router DG834
202-10005-05, June 2005
TM technology. Each Ethernet LAN
3-7