Using Ez Scan Software; Dsp Firmware Update - Whistler WS1080 Owner's Manual

UPDATING EZ Scan SOFTWARE
Using EZ Scan Software to update the WS1080
1. Turn off the Scanner. Disconnect the USB cable
from the scanner, but keep the USB cable
connected to your computer.
2. While pressing the Menu key, connect the USB
cable to the Scanner. The current boot and CPU
versions appear on the display, followed by the
CPU SW Upgrade prompt.
NOTE: To exit this mode without updating press
MENU again.
3. Select Check for CPU Firmware Updates in the
update menu.
4. Click Check for Updates on the update screen.
5. If there are available updates, click Update My
Scanner.
6. When complete, click Done.
DSP Firmware Updates
1. Turn off the Scanner.
2. Connect the scanner to your computer using
the USB cable supplied. The computer should
recognize the scanner's MicroSD card as a new
drive. If an autorun screen appears, close it.
3. Select Check for DSP Firmware Update in the
update menu.
4. Click Check for Updates.
5. If there are available updates, click Update My
Scanner.
6. When complete, click Done.
49