Service-Sensor Retry - HP ProCurve MSM310 Reference Manual

CLI commands
Config context

service-sensor retry

Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
service-sensor retry <retries>
Specify how many retries the service sensor will attempt when polling the target device.
When the retry limit is reached, the radio on the AP is turned off.
Parameters
<retires>
service-sensor timeout
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
service-sensor timeout <seconds>
Sets how long the service sensor will wait for a response to a poll before timing out.
Parameters
<seconds>
ip name-server
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
ip name-server <primary> [<secondary>] [<third>]
Sets the primary and secondary DNS servers overriding dynamically assigned ones.
Parameters
<primary>
<secondary>
<third>
ip name-server cache
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
ip name-server cache
Enables the DNS cache.
no ip name-server cache
Disables the DNS cache.
Once a host name has been successfully resolved to an IP address by a remote DNS server, it is
stored in the cache. This speeds up network performance, as the remote DNS server now does not
have to be queried for subsequent requests for this host.
The entry stays in the cache until:
 an error occurs when connecting to the remote host

the time to live (TTL) of the DNS request expires
 the AP is restarted
2-34
Number of retries. Range: 0 - 100.
Length of timeout. Range: 1 - 5 seconds.
IP address of the primary DNS server.
IP address of the secondary DNS server.
IP address of the third DNS server.