This Quickstart shows you how to get started using the MSM422 Access Point (US J9358A/B, WW J9359A/B). After reading this Quickstart, you can visit www.hp.com/go/procurve/manuals and download documents of particular interest such as the MSM3xx / MSM4xx Access Points Management and Configuration Guide and the MSM7xx Controllers Management and Configuration Guide.
Reset button management tunnel to a controller, the Power light remains on and the Ethernet and Radio Press and quickly release the button to reset the MSM422. To reset the MSM422 to factory lights blink to indicate the presence of traffic.
Part 1, CSA C22.1. It should be installed in a similar orientation as in a ceiling installation. However, it is left to a qualified installer to determine how to install/secure the MSM422 in a plenum in an appropriate and safe manner. Plenum-rated cables and attachment hardware must be used.
If using a PoE injector, use Ethernet cables to connect your computer to the data in • A 10/100 or 10/100/1000 PoE-enabled switch. Various PoE-enabled switches are port of the PoE injector and the MSM422 to the data and power out port of the PoE available from HP ProCurve. injector.
E. Assigning an IP address to the MSM422 A factory-default MSM422 is assumed. By default the MSM422 operates as a DHCP client. This means that if the network has a DHCP server, the MSM422 will automatically receive a new IP address in place of its default In a Web browser, enter the address: https://192.168.1.1.
You may have to wait a short time for this wireless network name to appear in the • On both radios of a rev A MSM422, the 5 GHz DFS channels are enabled and can be used. wireless networks list.