Context Hierarchy - HP ProCurve MSM310 Reference Manual

Context hierarchy

CLI commands are grouped into functional contexts. The following table shows the context
hierarchy and the command used to switch from the parent context.
Context hierarchy
View context
Enable context
Config context
WAN IP interface context
Port-2 interface context
VLAN interface context
Port-1 interface context
VLAN interface context
Wireless context
Local mesh context
VLAN interface context
GRE interface context
Virtual AP context
Syslog destination context
SNMP user context
SNMP notification receiver context
RADIUS context
IP_QOS context
Network profile context
Sample CLI session
This sample CLI session shows you how to set the wireless port to support 802.11a on
channel 60 with medium distance between access points. (The CLI prompt is shown in bold.)
CLI> enable
CLI# config
CLI(config)# interface wireless
CLI(config-if-wlan)# dot11 a 60
CLI(config-if-wlan)# distance medium
CLI(config-if-wlan)# end
CLI(config)# end
CLI# quit
Command to switch from parent context
(This is the root context. No command is needed.)
enable
config
interface ip
interface ethernet port-2
interface vlan <id>[-<id2>]
interface ethernet port-1
interface vlan <id>[-<id2>]
interface wireless <number>
local mesh profile <name>
interface vlan <number>
interface gre <name>
virtual ap <name>
logging destination <name>
snmp-server user <name>
snmp-server notification receiver <host>
radius-server profile <name>
ip-qos profile <name>
network-profile <name>
Introduction
Context hierarchy
1-7