Access-Controller Restrict Location - HP ProCurve MSM310 Reference Manual

access-controller restrict location

Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
access-controller restrict location (gateway | mac <mac address>)
Identifies the access controller the AP will communicate with.
Parameters
Use the default gateway as the access controller.
gateway
Use the specified MAC address as the gateway.
mac
MAC address. Specify 6 pairs of hexadecimal numbers separated by
<mac address>
colons, with the values a to f in lowercase. For example: 00:00:00:0a:0f:01
service-sensor
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
service-sensor
Enables the service sensor. The service sensor polls a target device at present intervals. If the
device does not respond, the radio is shut off.
no service-sensor
Disables the service sensor.
service-sensor
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
service-sensor (gateway | address<ip address>)
Sets the target device the service sensor will poll. This can be the default gateway or a specific IP
address.
no service-sensor
Disables the service sensor.
Parameters
The service sensor will poll the default gateway.
gateway
The service sensor will poll another device.
address
IP address of the other device. For example: 192.168.10.10
<ip address>
service-sensor poll
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
service-sensor poll <seconds>
Sets the poll frequency.
Parameters
Poll frequency. Range: 1 - 3600 seconds.
<seconds>
CLI commands
Config context
2-33