Samsung SHR-5040 User Manual page 40

keyboard dialog
user id
password
shift
 site iP
Sets the IP address for the main system to be
connected to the network. If the connection mode
is set to STATIC-IP, the user needs to enter the IP
address directly.
If the connection mode is either DHCP or ADSL, the IP
address provided by the DHCP server or ADSL carrier
will be automatically displayed. If a DHCP or ADSL
connection attempt fails, 000.000.000.000 will be
displayed. In this case, turn off the power of the main
system and wait for a while. And then, turn on the
power and retry the connection.
 subnet Mask
Sets the subnet mask address for the main system.
 gateway
Sets the gateway address for the main system.
 Port(tcP)
The port number is selectable from 554 to 2048.
 Bandwidth
Set the maximum speed of transferring video data over
a network.
36_ menu setup
SHR-5042_Eng_02.indd 36
user
****
Back
ok Cancel
Web Viewer Port Settings
web viewer port setting
port 80
move/Control select
Set the number of a port where Web Viewer will be
used on the Web browser. The port number is set to
80 by default.
 Port
Set the number of a port where Web Viewer will be
used on the Web browser. You can set the port
number to 80 to 60080. (The port number is set to 80
by default.)
 If the port for Web Viewer in the DVR is closed
by the firewall or sharing equipment, Web
Viewer cannot run on the Web browser.
In this case, contact the network administrator.
ok Cancel
exit
2008-01-25 오전 9:31:28