Connecting The Handset - Avaya 1140E User Manual

1. Form a small bend in the cable.
2. Thread the adapter cord through the channels in the stand.
To use PoE, your connected LAN must support PoE. A PoE-enabled LAN
delivers power to your IP Deskphone over the CAT-5 network cable and
an AC adapter is not required.
WARNING
If you are connected to a PoE connection do not use the
AC power adapter
To use gigabit Ethernet, you must connect to the LAN through CAT-5e (or
later) cables.

Connecting the handset

Use the following procedure to connect the handset to the IP Deskphone.
1. Connect the end of the handset cable with a short straight section to
the handset.
2. Connect the end of the handset cable with the long straight section,
into the RJ-9 handset jack marked with the
the IP Deskphone.
3. Form a small bend in the cable.
4. Thread the handset cord through the channels in the stand so that it
exits behind the handset on the right side, using the handset cord exit
in the stand base marked with the
page 48.
Using your Avaya 1140E IP Deskphone
+
symbol on the back of
+
symbol as shown in Figure 9 on
49