Interrupt Selection - National Instruments PC-LPM-16/PnP User Manual

Note:

Interrupt Selection

Note:
National Instruments Corporation
Table C-3.
Switch Setting
A9 A8 A7 A6 A5
1 1 0 1
1 1 0 1
1 1 1 0
1 1 1 0
1 1 1 1
1 1 1 1
Base I/O address values hex 000 through 0FF are reserved for system use.
Base I/O address values hex 100 through 3FF are available on the I/O
channel.
The PC-LPM-16 connects to any one of the six interrupt lines of the
computer I/O channel. A jumper selects the interrupt line on one of the
double rows of pins located above the I/O slot edge connector on the
PC-LPM-16 (see Figure C-1). To use the PC-LPM-16 interrupt
capability, select an interrupt line and place the jumper in the
appropriate position to enable that particular interrupt line.
The interrupt lines that the PC-LPM-16 hardware supports are
IRQ<3..7>, and IRQ9.
Using interrupt line 6 is not recommended. The diskette drive controller
uses interrupt line 6 on most IBM PC and compatible computers.
After you select an interrupt level, place the interrupt jumper on the
appropriate pins to enable the interrupt line.
The interrupt jumper setting is W3. The default interrupt line is IRQ5,
which you select by placing the jumper on the pins in row 5, as shown
in Figure C-3. To change to another line, remove the jumper from IRQ5
and place it on the new pins.
Appendix C
Switch Settings with Corresponding Base I/O Address and
Base I/O Address Space (Continued)
Base I/O Address
(hex)
0 340
1 360
0 380
1 3A0
0 3C0
1 3E0
C-9
Using Your PC-LPM-16 (Non-PnP) Board
Base I/O Address
Space Used (hex)
340–34F
360–36F
380–38F
3A0–3AF
3C0–3CF
3E0–3EF
PC-LPM-16/PnP User Manual