Table of Contents
Advertisement
Chapter 1
Introduction
Unpacking
PC-LPM-16/PnP User Manual
The mating connector for the PC-LPM-16/PnP is a 50-position,
polarized, ribbon socket connector with strain relief. National
Instruments uses a polarized (keyed) connector to prevent inadvertent
upside-down connection to the PC-LPM-16/PnP. Recommended
manufacturer part numbers for this mating connector are as follows:
•
Electronic Products Division/3M (part number 3425-7650)
•
T&B/Ansley Corporation (part number 609-5041CE)
The following are the standard ribbon cables (50-conductor, 28 AWG,
stranded) that can be used with these connectors:
•
Electronic Products Division/3M (part number 3365/50)
•
T&B/Ansley Corporation (part number 171-50)
Your PC-LPM-16/PnP board is shipped in an antistatic package to
prevent electrostatic damage to the board. Electrostatic discharge can
damage several components on the board. To avoid such damage in
handling the board, take the following precautions:
•
Ground yourself via a grounding strap or by holding a grounded
object.
•
Touch the antistatic package to a metal part of your computer
chassis before removing the board from the package.
•
Remove the board from the package and inspect the board for loose
components or any other sign of damage. Notify National
Instruments if the board appears damaged in any way. Do not
install a damaged board into your computer.
•
Never touch the exposed pins of connectors.
1-6
National Instruments Corporation
Advertisement
Table of Contents
