Table of Contents
Advertisement
Installation and
Configuration
Hardware Installation
National Instruments Corporation
This chapter describes the installation and configuration of the
PC-LPM-16PnP. For information on installing and configuring the
PC-LPM-16, a non-PnP board, refer to Appendix C, Using Your
PC-LPM-16 (Non-PnP) Board.
You can install the PC-LPM-16PnP in any available expansion slot in
your computer. The following are general installation instructions, but
consult your computer user manual or technical reference manual for
specific instructions and warnings.
1. Turn off and unplug your computer.
2. Remove the top cover or access port to the I/O channel.
3. Remove the expansion slot cover on the back panel of the
computer.
4. Insert the PC-LPM-16PnP board into any 8-bit or 16-bit slot. It may
be a tight fit, but do not force the board into place.
5. Screw the mounting bracket of the PC-LPM-16PnP board to the
back panel rail of the computer.
6. Replace the cover.
7. Plug in and turn on your computer.
The PC-LPM-16PnP is installed.
2-1
Chapter
2
PC-LPM-16/PnP User Manual
Advertisement
Table of Contents
