Assembling And Installing; Step 1: Assembling The Stand - Mounting The Machine - Roland versaArt RE-640 Setup Manual

3. Assembling and Installing

Step 1: Assembling the Stand – Mounting the Machine
WARNING
CAUTION
Procedure

Attach the stand legs to the stand stay.
Place the stand legs with its horseshoe shaped bracket facing inside, and secure them by tightening the
bolts in the order given below. (8 locations in total) Loose bolts may cause the stand to wobble.
Lightly tighten the bolts in the upper 2 locations. (4 locations in total for right and
left)
Lightly tighten the bolts in the 2 locations on the side. (4 locations in total for right
and left)
Fully tighten the bolts in the upper 2 locations. (4 locations in total for right and
left)
Fully tighten the bolts in the 2 locations on the side. (4 locations in total for right
and left)
Place the leg with the horseshoe shaped bracket facing inward.
Place the stand stay as shown in the figure below.
Make this area
equally spaced.
22
Perform this task with all power switches left switched off.
Otherwise sudden movement of the machine may cause injury.
Unpacking and installation must be carried out by six or more person-
nel.
Otherwise the machine or the stand may fall, resulting in injury.
Hexagonal
wrench
Bolts
Horseshoe
Stand leg
shaped bracket
Side view
Stand leg
Hexagonal
wrench
Stand stay
Top view
Stand stay
Stand leg
Bolts
Align them parallel
to each other
Stand stay