Step 2: Make The Network Settings On The Printer - Roland versaArt RE-640 Setup Manual

7. Network Settings

Step 2: Make the Network Settings on the Printer

Important
The addresses used in this section are merely example settings. For detailed information about the settings,
consult your network administrator.
1.
Set the IP address.

Press

MENU
SYSTEM INFO.
w
SYSTEM INFO.
NETWORK
x
IP ADDRESS
000 . 000 . 000 . 000
y
IP ADDRESS
192 . 000 . 000 . 000
z
IP ADDRESS
192 . 000 . 000 . 000
y
{
Repeat
|
IP ADDRESS
192 . 168 . 000 . 003
NETWORK
IP ADDRESS
2.
Set the subnet mask.

NETWORK
IP ADDRESS

NETWORK
SUBNET MASK
46
.
Press
left appears.
Press
Press
[IP ADDRESS]: 192.168.000.XXX
Note: Here, "XXX" can be any number between 2 and 254.
However, be sure to eliminate the number overlapping with the setting you
made in Step 1. Here, "192.168.000.003" shall be entered as an example.
For the part corresponding to "192.168.000," apply the same value as the
setting of your computer.
Press
Press
z
and to set all the address numbers.
When you finish making the setting, press
Press
The screen shown in the figure appears again.
Press
Press
several times until the screen shown on the
in this order.
three times.
to select the address number.
.
.
.
twice.
.