Fujitsu primergy TX150 User Manual page 255

●
The screen is distorted when Linux shuts down.
Although the screen display may be distorted when shutting down the system in the Linux environment,
the system is shut down normally. This has no harmful effect on the system.
●
Nothing is displayed on the screen.
• Check to see whether the display cable is connected properly. If it is not connected, turn the server off
and then connect the cable. For the connection location, refer to "Start Guide".
• Check that the brightness volume and contrast volume of the display are adjusted correctly. If they
need to be adjusted, perform the necessary adjustments.
For details, refer to the manual of the display.
• There may be an error in the system area of the memory. Contact an office listed in the "Contact
Information" of "Start Guide".
●
Typing the keyboard does not display any characters, or the mouse cursor
does not move.
Check to see whether the keyboard and mouse are connected properly. If they are not connected, turn the
server off and then connect the cables to the server. For the connection location, refer to "Start Guide".
●
The screen shakes.
If a device that produces a strong magnetic field such as a television or speaker is near the display, place
them further away from the display.
The display may also shake if a nearby cell-phone receives a call. Do not use a cell-phone near the
display.
■ Floppy Disk Drive
●
Cannot read or write to the floppy disk.
The head may be dirty. Clean the drive using a cleaning disk. For cleaning methods, refer to "9.1.2
Cleaning" ( Pg.250).
●
Cannot write to the floppy disk.
The write protection of the floppy disk may be applied.
Flip the switch on the disk to allow writing.
■ SCSI Device (Internal / External)
●
The unit does not operate properly.
• Check to see whether the internal cable is connected properly. If it is not connected, correctly connect
the internal cable. For the connection location, refer to "7.6.2 Installable 5-inch Internal Devices and
Notes" ( Pg.208).
• For SCSI devices, check to see whether the SCSI ID and terminator are set correctly. If they are not
set, correctly set the SCSI ID and terminator.
PRIMERGY TX150 S4 User's Guide
9
255