How To Install A Dvd-Ram Unit - Fujitsu primergy TX150 User Manual

11
Setup SCSI-ID.
Use the utility supplied with the SCSI card.
For details on how to use the utility, refer to the manual of SCSI card.
For SCSI-ID of each option, refer to "
( pg.208)

7.6.4 How to Install a DVD-RAM Unit

Before installing a DVD-RAM unit, remove the preinstalled CD-ROM drive unit. Perform the following
procedures to install a DVD-RAM unit.
1
Turn off the server and connected devices, and unplug all power cables from
the outlet.
2
Remove the side and front covers.
"7.2 Removing and Attaching Covers" (pg.186)
3
Remove the IDE cable and power cable from the CD-ROM drive unit.
4
Remove the CD-ROM drive unit.
Pull the CD-ROM drive unit out slowly towards you, keeping the tabs on the 5-inch storage bay
rails (on both sides) pressed inward.
5
Detach the 5-inch storage bay rails from the removed CD-ROM drive unit.
Remove four screws that fix the 5-inch storage bay rails to detach.
■
Installable 5-inch Internal Devices and SCSI-IDs"
Tabs
PRIMERGY TX150 S4 User's Guide
7
211