Fujitsu primergy TX150 User Manual page 225

table: Items on the Peripheral Configuration Submenu
Item
USB Enable Ports • None
• All (Initial value)
• Disabled
USB 2.0 Host Controller
• Enabled (Initial value)
USB BIOS Supported Auto (Unchangeable)
Devices
USB Boot Delay Os (Unchangeable)
ATA Controller Config Press the [Enter] key to display the [ATA Controller Config] submenu.
P-ATA Maps To Primary (Unchangeable)
Primary IDE Channel
Enabled (Unchangeable)
Secondary IDE
Enabled (Unchangeable)
Channel
Diskette Controller
Enabled (Unchangeable)
Mouse Controller
Auto Detect (Initial value)
• Disabled
LAN Controller
• Enabled (Initial value)
• Disabled (Initial value)
LAN Remote Boot
• Enabled
SCSI Controller
Enabled (Unchangeable)
SCSI Option ROM Scan
Enabled (Unchangeable)
Setting
Sets whether or not to use the USB port.
Sets whether or not to enable the USB controller
(2.0 standard).
You can set this item only when [USB Enable Ports]
is set to [All].
Sets whether the USB device can be used on the OS
that does not support USB.
Sets the delay time by the second for initializing
USB mass storage device during the POST.
Sets the parallel ATA mapping.
Sets whether or not to enable primary IDE channel.
Sets whether or not to enable secondary IDE
channel.
Configures the floppy disk controller.
Sets whether or not to use the mouse connected to
the mouse port.
Sets whether to enable or disable the onboard LAN
controller.
Sets whether or not to perform a network boot.
This function allows booting the server via the
network. It is used for remote installation of the OS,
etc.
You can set this item only when [LAN Controller]
is set to [Enabled].
Sets whether to enable or disable the onboard SCSI
controller.
Sets whether or not to initialize the extended ROM.
PRIMERGY TX150 S4 User's Guide
Description
8
225