Rimage PrismPlus! User Manual page 23

Rimage PrismPlus! User Guide
4. Install the supply roller as shown. Leave some slack in the ribbon leader.
a. Press the operator button until the printer tray comes out. The ribbon is
threaded to the front of the Prism.
b. Remove the tape from the
c. Remove the adhesive strip from the ribbon leader.
take-up roller.
5. Load the
a. Place the new empty cardboard core on the take-up
roller. It is designed to fit only one way.
b. Place the take-up roller on top of the ribbon leader as
shown.
-
Important! The gear must be on the correct side.
c. Pull the ribbon leader up over the cardboard core and attach the adhesive strip to the cardboard core so that the
edges on the ribbon leader are aligned to the edges of the cardboard core. The arrow illustrates the wrap direction.
d. Roll the ribbon leader so that it is wrapped only once around the
roller.
-
Important! Do not roll past the marking on the leader that states
STOP - Wind Leader Onto Take-up Core Stopping here.
20
printer tray.
Supply Roller
Gear
Adhesive Strip
Cardboard Core
Ribbon Leader
110635_J