National Instruments Data Acquisition Device E Series User Manual page 167

Appendix A Device-Specific Information
DAQPad-6020E LED Patterns
LED
On
Dim
Off
1 blink
2 blinks
4 blinks
DAQPad-6020E Specifications
NI DAQPad-6020E Pinout
Note Some hardware accessories may not yet reflect the NI-DAQmx terminal names. If
you are using an E Series device in Traditional NI-DAQ (Legacy), refer to Table 1-5,
Terminal Name
E Series User Manual
The DAQPad-6020E has an LED on the front panel. Refer to Table A-4 for
descriptions of each LED state.
Table A-4. DAQPad-6020E LEDs
The device is configured.
The device turns off or goes into the low-power, suspend mode when
the computer is powered down.
The device is recognized but not configured.
The device displays this pattern if the host computer detects the
DAQPad but cannot configure it. This problem arises if NI-DAQ is
not properly installed, or there are no system resources available.
If this pattern is displayed, contact National Instruments.
Refer to the NI DAQPad-6020E Family Specifications for more detailed
information on the devices.
Figure A-33 shows the NI DAQPad-6020E device pinout.
Equivalents, for the Traditional NI-DAQ (Legacy) signal names.
DAQPad-6020E State
—
A-32 ni.com