National Instruments Data Acquisition Device E Series User Manual page 125

Note In NI-DAQmx, you can indirectly route timing signals not shown in the above
diagrams to RTSI. For a detailed description of which routes are possible on your device,
in MAX, select Devices and Interfaces, your device, then select the Device Routes tab.
© National Instruments Corporation
plugged into Slot 2 of the chassis. E Series devices can accept timing
signals from the PXI star trigger line, but they cannot drive signals onto it.
For more information about the star trigger, refer to the PXI Hardware
Specification Revision 2.1.
PXI Star 6
PXI Trigger <0..5>
6
PXI Trigger 7
Figure 8-2. PXI E Series Signal Connection Scheme
Refer to the Timing Signal Routing
for a description of the signals shown in Figure 8-2.
Chapter 8 Real-Time System Integration Bus (RTSI)
DAQ-STC
Switch
section of Chapter 7,
8-3
ai/ConvertClock
ai/StartTrigger
ai/ReferenceTrigger
ao/SampleClock
ao/StartTrigger
Ctr0Source
Ctr0Gate
Ctr0InternalOutput
Ctr0Out
ai/SampleClock
ai/PauseTrigger
ai/SampleClockTimebase
ao/SampleClockTimebase
Ctr1Source
Ctr1Gate
ao/PauseTrigger
20MHz Timebase
Master Timebase
Digital Routing,
E Series User Manual