Table of Contents
Advertisement
Adjust the camera
1
Be sure to view the monitor for adjustment when the camera angle is adjusted.
Connect the monitor for adjustment (e.g. a small LCD) to the monitor output connector, and
adjust the camera angle.
When determining the camera angle, repeat fine follow the adjusting procedure of q, w, and
e shown below.
q Loosen the panning lock screw and rotate the camera head horizontally to adjust panning,
and tighten the panning lock screw. (Panning range: ±170 °)
w Loosen the tilting lock screws and rotate the camera head vertically to adjust tilting, and
tighten the tilting lock screw. (Tilting range: ±75 °)
e Rotate the tilt adjusting table, and adjust the azimuth angle of the image. (Azimuth range: ±100 °)
Important:
• The panning lock screw and the tilting lock screw shall be securely tightened.
(Recommended tightening torque: 0.59 N·m {0.44 lbf·ft})
Note:
• The video output to the BNC connector will be interrupted while an adjusting monitor is con-
nected to the monitor output connector.
• At the same time for the pan and tilt adjustments, make focus adjustments of Step 2.
28
Tilt adjusting table
Panning table
Panning lock screw
Tilting lock screw
Monitor output connector
(RCA)
Hide quick links:
Advertisement
Table of Contents
