Table of Contents
Advertisement
2
Adjusts the focus.
Focus adjustment shall be performed when camera
angle adjustment are performed.
Adjust the focus by following the adjusting proce-
dure of q, w, and e shown below.
q Loosen the zoom lock knob and move the
knob between TELE and WIDE to obtain the
appropriate angle of view, and then tighten the
zoom lock knob.
w Loosen the focus lock knob, make coarse
adjustment of the focus, and then tighten the
focus lock knob.
e Perform major adjustment of back focus
through the setup menu or perform major
adjustment by following Steps 3 and 4 below (+ Operating Instructions (PDF)).
Note:
• Reset the back focus position to the CS mount default position before the back focus adjust-
ment. (Hold down the right and left buttons simultaneously for 2 seconds or more, or move the
cursor to "MANUAL-ADJ" of "BACK-FOCUS SETUP" in the setup menu and press the right and
left buttons simultaneously for 2 seconds or more after pressing the setting button.)
3
Press the [ABF1] button after adjusting the view angle while viewing the monitor
for adjustment.
The ABF operation indicator (+ page 12) lights, the focus position is displayed in the lower part of
the screen, and the back focus is automatically adjusted.
NEAR
......... | ..........
INDICATOR XXXX FOCUSING
FAR
Focus lock knob
Zoom lock knob
NEAR
NEAR
FAR
FAR
WIDE
WIDE
TELE
TELE
29
Hide quick links:
Advertisement
Table of Contents
