Preparations - Panasonic WV-CW634S Installation Manual

Preparations

When installing the camera on a wall or a ceiling, there are two methods as specified below.
(+ Next page)
• Using a two-gang junction box (locally procured)
• WV-CW634S: Using the mounting base (accessory)
WV-CW634F: Using the mounting base WV-Q115A (option)
Refer to all work related to the installation of this product to qualified service personnel or system
installer.
• The mounting base WV-Q115A is optional for WV-CW634F. Use the screws supplied with the
camera mount bracket.
Important:
• Prepare the mounting screw according to the material of the area where the attachment plate
(accessory) is to be installed. In this case, wood screws and nails should not be used. For
mounting a camera on a concrete ceiling, use an anchor bolt (M4) or an AY plug bolt (M4) for
securing.
(Recommended tightening torque M4: 1.6 N·m {1.18 lbf·ft})
• Required pull-out capacity of a single screw/bolt is 196 N {44.06 lbf} or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the area shall
be sufficiently reinforced.
• When using an optional mount bracket, refer to the operating instructions of the bracket in use.
The mounting conditions of the camera mount bracket are described as follows:
Installation Applicable mount
place bracket
Ceiling/wall Two-gang junction box
(locally procured)
Ceiling/wall WV-Q115A or mounting
base (accessory)
Ceiling/wall Optional mount brackets
(Refer to page 40)
* M ake sure that the installed mount bracket can support more than 5 times of the total weight of
the camera, attachment plate and screws.
14
Recommended Number
screw of screw
M4 or equivalent
M4 or equivalent
–
Minimum pull-out
strength
(per 1 pc.)
4 pcs. 196 N {44.06 lbf}
4 pcs. 196 N {44.06 lbf}
– *