Adjust The Camera - Panasonic WV-CF504 Installation Manual

Adjust the camera

z
Be sure to view the monitor for adjustment when the camera angle is adjusted.
Connect the monitor for adjustment (e.g. a small LCD) to the monitor output connector, and
adjust the camera angle.
When determining the camera angle, repeat fine follow the adjusting procedure of q, w, and
e shown below.
q Loosen the panning lock screw and rotate the camera head horizontally to adjust panning,
and tighten the panning lock screw.
w Loosen the tilting lock screws and rotate the camera head vertically to adjust tilting, and
tighten the tilting lock screws.
e Rotate the tilt adjusting table, and adjust the azimuth angle of the image.
Important:
• The panning lock screw and the tilting lock screw shall be securely tightened.
(Recommended tightening torque: 0.59 N·m {0.44 lbf·ft})
Note:
• The video output to the BNC connector will be interrupted while an adjusting monitor is con-
nected to the monitor output connector.
• At the same time for the pan and tilt adjustments, make focus adjustments of Step 2.
22
75 °
Panning lock screw
Tilt adjusting table
Tilting lock screw
Panning table