Adjust the camera
z
Be sure to view the monitor for adjust-
ment when the camera angle is adjust-
ed.
Connect an adjusting monitor (such as a
small LCD monitor) to the monitor out
connector (for adjustment) and adjust
the camera angle.
Turn on the power after connecting the
adjusting monitor.
Follow the steps q, w and e to adjust
the camera angle.
q Loosen the panning lock screw,
rotate the camera horizontally to
adjust pan direction, and then tight-
en the panning lock screw.
w Loosen the tilting lock screw, rotate
the camera vertically to adjust tilt
direction, and then tighten the tilting
lock screw.
e Rotate the tilt adjusting table to adjust the azimuth angle of the image.
Note:
• At the same time for the pan and tilt adjustments, make focus adjustments of Step 2.
Important:
• The panning lock and tilting lock screws shall be securely tightened.
(Recommended tightening torque: 0.59 N·m)
x
Adjusts the focus.
At the same time for the pan and tilt adjustments, make focus adjustments.
Adjust the focus by following the adjust-
ing procedure of q, w and e shown
below.
q Hold down the auto back focus but-
ton for 5 sec. or more to set ABF to
the standard position.
w Loosen the zoom lock lever and
move the lever between TELE and
WIDE to obtain the appropriate
angle of view.
e Loosen the focus lock knob, rotate
the focus adjustment grip to adjust
the focus coarsely, and then tighten
the focus lock knob.
26
75 °
Tilt adjusting table
Panning table
Panning lock screw
Focus
adjustment grip
Monitor out connector
for adjustment
Tilting lock screw
Focus lock knob
Zoom lock knob