Procedure 2 Message Check; Message Check - Toshiba Satellite T110 Maintenance Manual

Chapter 2 Troubleshooting Procedures
Procedure 2

Message Check

When the power is turned on, the system performs the Initial Reliability Test (IRT) installed
in the BIOS ROM. When the test detects an error, an error message is displayed on the scree
Turn on the computer and check the message on the screen. When an OS starts from the 2.5"
HDD, go to Procedure 3. Otherwise, start with Check 1 below and perform the other checks
as instructe d.
Check 1 If either of the following mess
messages do not appear, perform Check 3.
Insert system disk in drive
Press any key when ready .....
Non-System disk or disk error
Replace and press any key when ready
Check 2 Using the SYS command of the Free-DOS; transfer the system to the 2.5" HDD.
If the system is not transferred, go to Procedure 3. Refer to the Free-DOS Manual
for detailed operation.
If the following message appears on the display, the system program has been
transferred to the HDD.
System Transferred
If an error message appears on the display, perform Check 3.
Check 3 2.5" HDD(s) and the connector(s) of system board may be defective (Refer to the
steps described in Chapter 4, Replacement Procedures for disassembling.). In
HDD(s) to the
Procedure 3.
Satellite T110 / Satellite Pro T110 / PORTEGE T110 Maintenance Manual (960-Q08)
ages appears, go to Check 2. If the following
or
connector(s) firmly. If it is (or they are) firmly connected, go to
n.
sert
15