Installing The Touch Pad - Toshiba Satellite T110 Maintenance Manual

Chapter 4 Replacement Procedures

Installing the touch pad

The following describes the procedure for installing the touch pad.
1. Peel off the separator covering on the sensor portion of a new touch pad.
NOTE: Do not reuse the touch pad so that it can not be used after peeling off from the
computer. Be sure to stick a new touch pad.
When sticking the touch pad, be careful not to get the bubbles under the touch
pad.
2. Stick and install the touch pad on the top cover assembly.
3. Connect the touch pad FFC to the connector on the touch pad.
4. Install the touch pad plate and the touch pad board, secure it with the following
screws.
 M2.0x2F FLAT BIND screw
5. Connect the touch pad FFC and the touch pad board FFC to the connector on the
touch pad board.
Satellite T110 / Satellite Pro T110 / PORTEGE T110Maintenance Manual (960-Q08)
x8
37