Installing The Display Assembly - Toshiba Satellite T110 Maintenance Manual

Chapter 4 Replacement Procedures

Installing the display assembly

The following describes the procedure for installing the display assembly.
1. Inserting the pole of hinge to the hole of hinge assembly, set the display assembly
with hands on the base assembly.
2. Secure the hinges with the following screws.
‧
M2.0 4F
NOTE: Be sure to apply the locktight to the screws instructed in the figure above.
3. Connect the LCD harness to the connector on the system board.
Satellite T110 / Satellite Pro T110 / PORTEGE T110Maintenance Manual (960-Q08)
FLAT BIND screw
Figure 4-8-10 Secure the hinge screws
x4
28