Toshiba Satellite T110 Maintenance Manual page 193

Chapter 4 Replacement Procedures
4.13 CPU heat sink
Removing the CPU heat sink
The following describes the procedure for removing the CPU heat sink (See Figure 4-13-1).
1. Disconnect the Heat sink cable from the connector on the system board
2. Loose the following screws securing the heat sink holder along 1 to 3.

M2.03.0F FLAT BIND screw x3
NOTE: When removing the heat sink holder, be sure to remove the screws in the reverse
order of the number marked on the holder.
Figure 4-13-1 Remove the CPU heat sink
45
Satellite T110 / Satellite Pro T110 / PORTEGE T110 Maintenance Manual (960-Q08)