Hysteresis Read; Present Value Read - Omron CQM1H series Operation Manual

Commands and Responses
Response

7-3-12 Hysteresis Read

Command
Command Code
Parameter
Response

7-3-13 Present Value Read

Command
Command Code
Parameter
Response
216
If the correct command code or parameter is set to the output word, the same
command code or parameter will be set to the input word.
If the wrong command code or parameter is set to the output word, one of the
following error codes will be set to the input word.
E000: This error code will be set to the input word if a nonexisting command code
is used.
E001: This error code will be set to the input word if the parameter is not within
the range covered by the Unit.
This command is used to read the hysteresis.
Parameters are not used with this command.
If the correct command code or parameter is set to the output word, the same
command code or parameter will be set to the input word.
If the wrong command code or parameter is set to the output word, one of the
following error codes will be set to the input word.
E000: This error code will be set to the input word if a nonexisting command code
is used.
This command can be used only when the timing hold in operation mode A is set
to normal.
This command is used to read the present measured value after scaling.
Parameters are not used with this command.
If the correct command code or parameter is set to the output word, the present
conversion data will be set to the input word.
Section 7-3
Range: 0001 to 0999
Default value: 0001
Sign
0: Positive
F: Negative
Value
Range: 0 to 9999